Tel:86-311-89292334 Fax:86-311-89292334

Concrete pump and pump tube connection

The article Time : 2019-01-14

Concrete pump and pump pipe can be used to transport concrete to a long distance. At present, the common connection methods are I-type connection, L-shaped connection and U-shaped 

connection. No matter which connection method is adopted, it must be adhered to. The principle of the construction process is greatly reduced, so it is better to decide which connection 

method to use according to the construction site.we are provide stationary pump pipe,you can buy it.

:I type joint

After the pump outlet is directly connected to the pump tube, set it straight ahead.

: L-shaped joint

Connect the pump outlet to the pump tube and connect the 3-meter straight tube to a 90-bend tube.

Third: U-shaped joint

After the pump outlet is connected with the spinal canal, connect the 3 m straight tube and connect the two 90 elbows into a 180 horizontal elbow.

Wear-resistant pump tube processing method

There are many types of pump tubes, including wear-resistant pump tubes, thick-wall pump tubes, thin-wall pump tubes, and wear-resistant pump tubes. Many of them are also in the 

category of machining. The most used ones are stamping, forging and roller processing. , rolling method, bulging method, stretching method, bending method, and combined processing 

method. Wear-resistant pump tube processing is an organic combination of machining and metal pressure processing. The wear-resistant pump pipe is illustrated as follows: Forging method: 

The end or part of the pipe is punched out by a swaging machine to reduce the outer diameter. The common forging machine has a rotary type, a link type and a roller type. Stamping: The 

tube ends are expanded to the required size and shape with a tapered core on the press. Roller method: The core is placed in the tube, and the outer circumference is pressed by a roller 

for round edge processing.

 stationary pump pipe

Online Service×